Use ssh to access the management IP address of the switch to launch its CLI. Navigate to Configuration > RSTP and view the Ethernet ports. Start a web browser and connect to the switch at the IP address you established in the pre-configuration requirements above.Įnable (RSTP) as shown in the following steps.Įnsure that Spanning Tree is Disabled and 802.1W is Enabled. Follow the ICX 6430 instructions in step 3.Ĭonfigure the Brocade switch to use the Rapid Spanning Tree Protocol (RSTP), which was standardized by IEEE 802.1W.Īfter you perform the following steps, refer to the Brocade ICX 6430 and ICX 6450 Web Configuration QuickStart Guide for additional information about configuring Brocade ICX 6430 switches. See the Brocade ICXĦ430 and ICX 6450 Stackable Switches Hardware Installation Guide.īefore you configure the switch, follow steps 1 - 4 in the Brocade ICX 6430 and ICX 6450 Web Management Interface User Guide and the section on Prerequisite Configuration to attach a PC to the switch and assign an IP address to the management port using its Command Line Interface (CLI). Use the Brocade documentation to properly install the switch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |